looking for acrylic

[cpr]

I am in the process of making a couple of strikers. Can anyone give me any ideas as to where I could find some acrylic rods to use for making them. also, would there be a possiblity products like this would be at the convention next week. I plan on attending on friday.

[Poor Valley]

McMasters-Carr is the source I use for acrylic rod. Cat 3's are 1/4 in  8531K13, 3/8 in 8531K15.
Cost for 6' lengths  $1.67 and $3.30. Shipping rate very reasonable. Shipment recieved in one or two days.

They have a wide array of plastic materials.

Hope this helps.

[cpr]

Thank you for the info. I will be ordering some and making strikers soon.

[Bulldogmikey]

At the bottom of the home page, under Classifieds....calls is a supplier.

Mike