« previous next »
Pages: [1]   Go Down

Author Topic: bandsawing a paddle  (Read 2425 times)

Offline doublespurs21

  • Boss Tom
  • *****
  • Posts: 953
bandsawing a paddle
« on: December 18, 2013, 07:00:58 PM »
Logged

Offline doublespurs21

  • Boss Tom
  • *****
  • Posts: 953
Re: bandsawing a paddle
« Reply #1 on: December 18, 2013, 07:06:18 PM »



 a jig i use to cut out a paddle
Logged

Offline doublespurs21

  • Boss Tom
  • *****
  • Posts: 953
Re: bandsawing a paddle
« Reply #2 on: December 18, 2013, 07:09:34 PM »

Logged

Offline doublespurs21

  • Boss Tom
  • *****
  • Posts: 953
Re: bandsawing a paddle
« Reply #3 on: December 18, 2013, 07:13:26 PM »
Logged

Offline doublespurs21

  • Boss Tom
  • *****
  • Posts: 953
Re: bandsawing a paddle
« Reply #4 on: December 18, 2013, 07:18:45 PM »


i use this to trim off all the waste on the edges of the paddles. than all i have to do is belt sand the tip off and a little bit to round it off, 5 minutes at the most
Logged

Offline B-Ready

  • Boss Tom
  • *****
  • Posts: 7667
  • BeReady Custom Calls
Re: bandsawing a paddle
« Reply #5 on: December 18, 2013, 08:52:50 PM »
That's a neat  jig for the bandsaw ! Saves a lot of unhealthy dust in the shop. Lot safer than using a table saw too. Good tip!! *up*
Logged
Pages: [1]   Go Up
« previous next »