Osage Roost

Callmakers Corner => Callmakers Workbench => Topic started by: cpr on February 13, 2010, 07:54:19 AM

Title: looking for acrylic
Post by: cpr on February 13, 2010, 07:54:19 AM

I am in the process of making a couple of strikers. Can anyone give me any ideas as to where I could find some acrylic rods to use for making them. also, would there be a possiblity products like this would be at the convention next week. I plan on attending on friday.

Title: Re: looking for acrylic
Post by: Poor Valley on February 15, 2010, 10:55:14 AM

McMasters-Carr is the source I use for acrylic rod. Cat 3's are 1/4 in  8531K13, 3/8 in 8531K15.
Cost for 6' lengths  $1.67 and $3.30. Shipping rate very reasonable. Shipment recieved in one or two days.

They have a wide array of plastic materials.

Hope this helps.

Title: Re: looking for acrylic
Post by: cpr on February 22, 2010, 09:24:57 PM

Thank you for the info. I will be ordering some and making strikers soon.

Title: Re: looking for acrylic
Post by: Bulldogmikey on March 11, 2010, 10:22:27 AM

At the bottom of the home page, under Classifieds....calls is a supplier.

Mike